Oxford Nanopore Support | Oxford Nanopore Technologies

Community support

Subscribe
a member of the Nanopore support team aiding a customer at a conference

Contact support

You can contact our Customer Services and Technical Services teams round the clock using the contact support function.

How can I determine the number of reads that are being rejected due to adaptive sampling?

How can I determine the number of reads that are being rejected due to adaptive sampling?

You can determine the number of reads that are being rejected due to adaptive sampling via two methods:

  1. During the run: using the read length histogram in **MinKNOW **by ticking the box "Split by read end reason". If you are running in a mode where enough reads should be rejected to produce a peak of short reads, there should be a bimodal distribution with a peak at a base-count much lower than what you expect from the sample. The reads rejected by adaptive sampling will have the label "Adaptive sampling voltage reversal" and are shown in purple in the read length histogram.

  2. Immediately after the sequencing run starts: please ensure that an adaptive_sampling.csv file was initialized into the "other_reports" folder inside your /data/EXPERIMENT_NAME/SAMPLE_NAME/RUN_ID folder. This file will contain information about the final decision that was taken by adaptive sampling for each read. Filtering this adaptive_sampling.csv by “decision” allows the user to know not only the number of reads accepted/rejected but also the specific readIDs of each read accepted and rejected. Accepted reads will be marked as “stop_receiving” and rekected reads will be marked as “unblock”.

Back to software FAQs

Getting started

Your first experiment

Find out more

The Nanopore Community

Find out more

Managing your devices and account

Find out more

Nanopore technology explained

Find out more

Community posts

Full community members have access to posts and private channels